Syvecs AWD Controller - 2023+ Toyota GR Corolla

Syvecs AWD Controller - 2023+ Toyota GR Corolla Syvecs also sells an optional loom to allow external Burnout switches to be mounted and Live adjustment potentiometers which gives drivers the ability to adjust the AWD Duty on the move or go 2wd from the flick of a switch. (Rally Cars only and must be ordered with the Unit) Limp Protection options for large slip, high current, high temps which warn the driver but keep awd active unlike the OEM controllers which shut down the outputs which is not ideal with high horsepower or mid corner! With the use of the Syvecs Scal Software, users can connect to the Device and adjust over 40 maps to adjust the control of the solenoids/motors used in the AWD systems Some of the Maps available: 4 x Base Duty Tables 4 x Adders with enable maps: -Left Foot Braking -Front Slip -Rear Slip -Centre Slip 4 x Multipliers with enable maps -Steering Angle -AWD Temp -AWD Pressure -AWD Potentiometer -Tyre Diameter adjustment under sensors 2WD/ Burnout Mode -Via Dedication Switched input -Via Can bus Message -Via OEM Functions Limiters -Maximum Duty -Launch Control Limit -Duty Rate of Change -Decay/Hold Functions Limp Mode -Over Current Protection -Over Slip Protection -Over Temp Protection Cooling Pump control -AWD Cooling pump control logic Datastream -The Syvecs AWD Unit also has a dedicated Can bus transmit area where users can send variables from the AWD to external control units for monitoring or to OEM Canbus system via custom Identifiers and byte structuring Sensors / Switches -External sensors can be connected to the AWD module and then linearized in the Syvec's Scal Software Firmware and Software gets updated regularly, check out http://www.syvecs.com/forum/ to make sure you have the latest!