J's Racing Camber Joint - S1 Front - Honda S2000 AP1 / AP2

Fits all S2000 model years.
Anodized Forged 6061 CNC Aluminum construction. Includes laser engraved J's Racing stamp
Made in Japan.

The J's Racing Front Camber Joint S1 allows for additional front camber by shifting the camber range to 2°-5° of camber without roll center adjustment.

By redesigning the previous model, the new camber joints have been enhanced with the roll center adjuster function in addition to the original negative camber adjustment.

Material : Forged aluminum 6061
The surface is anodized red with a laser carved ‘J’s Racing” seal
Ball joint S45C
Ball stud SCM435 HB195-260, Fluctuation angle 33 degree all around

The front camber angle can be adjusted to the stock + 2 degree (+ 3 degree for S2).
The front roll center value can be adjusted back to the correct one.
The insufficient negative camber is always a problem for S2000. This product creates enough negative front camber by locating the lower ball joint at an eccentric angle from the center.
The product also corrects the front lower arm position back close to horizontal, so that the correct geometry is restored with the accurately adjusted roll center. [When you reduce the ride height, the front lower arm position becomes like a separated letter V]

Adjustable range: 2 to 3 degrees (3 to 5 degrees for S2)
Ride height: Recommended to the vehicle whose height is reduced more than 40mm

Included in the kit:
Camber Joint S1 x2
Clip x2
Castle nut x2

* The stock bolts are to be reused or use new stock ones.
Please apply the correct tightening torque. After the installment, it is necessary to properly adjust the ride height and alignment.
It is highly recommended to check the tightening condition of the bolt & nut periodically.
[Always check it before the track event or race]